node.js-- version 11.6.0git-- version 2.17.1- Build essentials or similar (specifically
g++-- version 7.3.1)
To deploy a new Plasma Chain, use the following commands:
0) $ npm install plasma-chain [-g] # install the plasma chain operator. Global flag is optional, if you don't
use global, just replace all of the following commands with `npm run plamsa-chain [command]`. If you can't install
globally without `sudo` then just use local!
1) $ plasma-chain account new # create a new account
2) # On Rinkeby testnet, send your new Operator address ~0.5 ETH.
You can use a faucet to get test ETH for free here: https://faucet.rinkeby.io/
2.5) $ plasma-chain list # list all the plasma chains which others have deployed to the Plasma Network Registry
3) $ plasma-chain deploy # deploy a new Plasma Chain.
Note you will be prompted for a unique Plasma Chain name & IP address.
If you are running on your laptop, just set the IP to `0.0.0.0` as you probably don't
want to reveal your IP to the public. However, if you are running in a data center and would
like to accept Plasma transactions & serve a block explorer to the public, go ahead and set an IP.
4) $ plasma-chain start # start your new Plasma Chain
You can also view your local block explorer at http:127.0.0.1:8000
5) [optional]
Open a new terminal. In this new terminal use the following command:
$ plasma-chain testSwarm # spam your Plasma Chain with tons of test transactions 😁
See: https://coderwall.com/p/plejka/forward-port-80-to-port-3000