J-Link EDU Reviver

使用方法

解压所有文件到同一目录中, 在命令行下执行

EDUReViver -run blinky
闪灯测试, 如果红灯闪烁12次, 说明设备能通过校验且网络通讯正常.

EDUReViver -run revive
去除多余的FlashDL之类的Features.

EDUReViver -run swd
打开SWD调试接口.

EDUReViver -run swd off
关闭SWD调试接口.

EDUReViver -run to11
转换V10到V11. 重新插拔后, 打开jlink commander会自动刷新固件.

EDUReViver -run to10
转换V11到V10. 重新插拔后, 打开jlink commander会自动刷新固件.

支持设备

J-Link V10/V11 所有版本, 目前为止所有固件. 支持错误添加了Features的正版. 但不能是山寨版. 我加了一些在线检测避免滥用. 一次只能支持一个设备, 支持配置为WinUSB驱动, 如果出现识别错误, 请在JLinkConfig配置程序中切换到Segger驱动.

免责声明

此工具仅供研究和学习使用, 请勿将其用于商业用途. 请勿在山寨版上使用, 有可能导致工具下架.

Introduce

This utility support all version of JLinkV10/V11. support genuine jlink brick by bad features. doesn't support illegal clones. some check applied on my utility to prevent running on clones. turn off winusb mode in JlinkConfig if you meet usb communicate problems.

Usage

extract all files to same folder. execute these commands in command prompt.

EDUReViver -run blinky
this payload blinks red LED 12 times. this should used to test your usb and network connection is fine.

EDUReViver -run revive
this payload remove all extra features.

EDUReViver -run swd
this payload unlocking SWD debug port on PCB.

EDUReViver -run swd off
this payload locking SWD debug port on PCB again.

EDUReViver -run to11
this payload turns your V10 to V11. unplug and replug usb cable, then flash new firmware in jlink commander.

EDUReViver -run to10
this payload turns your V11 to V10. unplug and replug usb cable, then flash new firmware in jlink commander.

Disclaimer

You can only use my utility for research propose, or repair your genuine jlink.