A software emulator for Tinkerforge Hardware
This software emulates some of the Tinkerforge hardware (see http://www.tinkerforge.com) on network protocol level. A client can connect as if it would connect to 'brickd'.
The emulator fully supports callbacks and configurable sensor values. The configurable sensor values are in some kind "predictable", which is useful for unit testing. In combination with a Qt based UI (see https://github.com/PlayWithIt/TFStubViz), you can manually override/control the sensor values using sliders or buttons (depending on the type). Doing this you can for example test some extreme or very specific combinations.
See this page to get a list of supported Tinkerforge devices and a short introduction: http://www.tinkerunity.org/wiki/index.php/DE/Projekte/Stackemulator_%28stubserver%29
- Linux (also compiles on Tinkerforge's RED Brick or RasPi)
- g++ 4.6.3 or higher (as on Raspberry PI, OpenSuse 13.1)
- clang++ 3.3 (llvm) or higher should work too
- optional: ALSA devel packages (libasound2-dev on Debian, alsa-devel on OpenSuse)
- run
makeormake -j4in the base directory for a debug-build - or run
make CONFIG=Releasefor an optimized build - or run
make USE_LLVM=1for a build with clang++ - or run
make DONT_USE_ALSA=1to exclude ALSA support if ALSA is not installed
- example configurations are in
src/stubserver, look for*.properties(e.g.motion.properties). The properties are used for device configuration - Sensors mostly use a 'ValueProvider' which calculates the values or reads the value from a text file (when when value changes + value).
- see
stubserver -?for command-line options src/stubserver/stubis an example to start the server on port 4225- your application or brickv can then connect to the emulated devices via
localhost:4225