Controller support/wiring status and default use-case

[SloMusti]

I am in the process of testing LaserWeb and am choosing the controller firmware had hardware, however there do not seem to be any clear directions yet.

Based on tickets support for Marlin/Smoothieware/Grbl is under development and thus would be a good idea to nicely display what id the default, most operational path.

Happy to prepare this, just ping your replies which firmware should be the best choice.

[Deleted user]

Smoothieware is definately the 'default'.
Second best is Grbl
Third is marlin
TinyG status is 'coming soon'

Smoothieware is the only one the does laser power as a variable function of
acceleration, makes for much better cuts and engraves.

In all cases gcode generation is working perfectly fine. Serial sending is
the WIP.
On 23 May 2016 19:10, "SloMusti" notifications@github.com wrote:

I am in the process of testing LaserWeb and am choosing the controller
firmware had hardware, however there do not seem to be any clear directions
yet.

Based on tickets support for Marlin/Smoothieware/Grbl is under development
and thus would be a good idea to nicely display what id the default, most
operational path.

Happy to prepare this, just ping your replies which firmware should be the
best choice.

—
You are receiving this because you are subscribed to this thread.
Reply to this email directly or view it on GitHub
#56