Unitree Go1 Free-Dog SDK C++
This repository is CPP port built on the commendable work of https://github.com/Bin4ry and team in free-dog-sdk. The code has a number of improvements, but it only has low level control.
Installation Guide
Use the standard process of cloning this repository, making the build folder, running cmake, running make, and installing.
Configuration of the dog and the SDK
Execute the following code on the robot's Raspberry Pi：
sudo vi /etc/sysctl.conf
Remove the comment in front of net.ipv4.ip_forward=1
sudo sysctl -p
sudo iptables -F
sudo iptables -t nat -F
sudo iptables -t nat -A POSTROUTING -o wlan1 -j MASQUERADE
sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
sudo iptables -A FORWARD -i wlan1 -o eth0 -j ACCEPT
sudo iptables -A FORWARD -i eth0 -o wlan1 -j ACCEPT
Do the following on the PC running this code：
sudo route add default gw 192.168.12.1
Configure the connection
You must establish a unitreeConnection object to get data. This takes in a tuple of the following:
- listenPort -- What port you should reserve for listening to connections. Arbitrary.
- addr -- The address of the robot. This should be 192.168.123.10 if you are connected via Ethernet.
- sendPort -- The port to send to. This should be 8007.
- localIP -- The IP of the computer running the code. It is recommended that this is set as 192.168.123.14.
Lowlevel Example
See example/example_position_lowlevel.cpp for an example.
Run the Lowlevel Position Example
Elevate the dog using a box so its feet are not touching the ground and the front right leg is free to move.
Then run
./free_dog_sdk_cpp_example_position_lowlevel
The dog's front right leg should do a sin motion.
Warnings
Absolutely NO warranty. This is not intentionally designed to but may inadvertently destroy your robot.
Network data for further development and analysis
Packet data is available here: https://drive.google.com/drive/folders/1sj5RmSSMArtuQ0Jn5zo_W-naarSg7qQg
LICENSE
MIT