[FR]: Add option to Control Off Limits Module
Closed this issue · 6 comments
Describe the feature you wish to make a request for
I have the off limits module in my M500+
I can control it's settings with the Raw command option
{"modules":{"DF":{"cut":0,"fh":1}}}
Where cut=0 is setting the mower to drive over the magnetic strip and mow inside the island. cut=1 is stop at the magnetic strip and don't mow the island
fh=1 enables the Shortcut for go home Und fh=0 disables the scortcuts.
This works with buttons that start a scrip that triggers this commands but I don't see the actual state.
Can you please show the state of the module? Or is there a way to read it out with a RAW Command?
Thanks
Raphael
Describe alternatives you've considered
No response
Additional context
No response
Would be nice if you could check if there is an off limits module installed, and if this option should be added in Home Assistant.
Do you perhaps mind sharing your credentials to landroid_cloud@trab.dk so I can test this (if you do, please refer to this issue in the message, so I can keep track of what the credentials are for)
Hi
Do you mean my landroid cloud credentials or are there some credentials saved in the integration?
I think my landroid has to be online that you can test it?
The Landroid Cloud credentials, and yes it should be online to test
fh=1 enables the Shortcut for go home Und fh=0 disables the scortcuts
What do you mean by shortcut?
https://wiki.worx.com/en/shortcut
You place two pieces of the magnetic strip onto the boundary wire and when landroid is on its way home and passes them it will drive away in a 90° angle.
Used to shorten the way home or on islands because otherwise it drives 3 times around them till it bounces off to search the right wire.
Will be added in next release