Chain link height

[ronbutterfield]

Please add a note to step 18, that the height the chain is attached to the sled should match the center of gravity of the router/sled assembly. This may need to be adjusted for cutting very thick or thin materials.

[davidelang]

and ideally you want the chain to be straight, so you want the motors out far enough for your 'standard' material (say an inch from the frame + what's needed for the center of gravity for the sled)

[BarbourSmith]

That's a great point, it should be clearer.

Feel free to edit the wiki page directly when you come across something like that, or I can.

[blurfl]

Has this been accomplished? If not, volunteers? 😁