/DueWindShield_Sensor_Wind

Firmeware for the WindLab Control and DAQ System

Primary LanguageC++

DueWindShield_Sensor_Wind

WindLab2

Mobile WindLab for teaching Windturbine aerodynamics at the Technische Universität Berlin. This is the firmware for the electronics, control, and data acquisition based on arduino due and a specially designed extension shield. It includes an electronic load, current and voltage measurement, rpm measurement via speed encoder, switch between motor and generator mode, motor controller board and stepper motor controller for pitch control. This boards controls the wind tunnel fan, the pitch stepper motor, the switch for motor and generator mode and the electronic load for an special designed Micro wind turbine. The wind tunnel is also designed and buil for this project. Pleas have a look at WindLab.de.

Getting Started

Download the firmware, and use it with the Arduino IDE. Set it up for the use with Arduino Due.

Prerequisites

All the necessary librarys should be in the download folder.

Some Standard Libraries are modified!!!!

Built With

Authors

  • Maik Wagner - Initial work - NGonka
  • stafqjcj - MatLab Code - stafqjcj

Acknowledgments

  • Adafruit
  • some more, exact will follow...

Hints

The E-Mail adress from TU-Berlin is not active anymore. If necessary please contact me via github.