FTDI Breakout Adapter
The FTDI Breakout Adapter convert interface from the FTDI Basic Breakout board pin-out to XH connector.
It is used for flashing software in Uart WiFi Board.
Repository Contents
- /Hardware - All Eagle design files (.brd, .sch)
- /Cables - Cables info
Description(Pin Interfaces)
CN1 Pin Descriptions:
This headers are for an FTDI port.
CN2 Pin Descriptions:
This connector is for your target board.
Pin | Name | Description |
---|---|---|
1 | VCC | VCC-CN1 with a jumper (Short or Open) |
2 | TX | TXD-CN1 |
3 | - | No connection. |
4 | RX | RXD-CN1 |
5 | GND | GND-CN1 |
6 | I/S | CTS-CN1 with a jumper (High, Low or No-connect) |
7 | OUT | DTR/RTS-CN1 |
Jumpers:
- JP1: This jumper changes the voltage level on CN2-I/S pin.
- JP2: This jumper allows you to supply voltage from FTDI port.
License
The repository is released under Creative Commons ShareAlike 4.0 International.
Distributed as-is; no warranty is given.