Macro - Hold Press + Input results in flickering input rather than continuously held input

[InfraredAces]

Expected Behavior

After configuring the macro with a single line and combination of inputs, while holding the macro trigger, it holds continuously holds the input down until the trigger is released.

Current Behavior

After configuring the macro with a single line and combination of inputs, while holding the macro trigger, the input will be held, but will occasionally flicker off

Context

Firmware Version: 0.7.8
Board Config Name: GP2040-CE_0.7.8_Haute42COSMOX.uf2
Device Name: S16
Operating System: 6.8.4-arch1-1 (64-bit)
Browser: Chromium

Steps to Reproduce

1. Configure Macro to a pin as seen in the screenshot below
2. Press and hold button for macro
3. View input flickering using https://hardwaretester.com/gamepad

Screenshots & Files

macrohold.mp4

[FeralAI]

@InfraredAces can you test out a build from #977 and see if that resolves the issue?

[InfraredAces]

@FeralAI Using the build from #977 does seem to resolve the issue. Help the Macro for 10+ seconds and I did not find any flickering through the gamepad tester