1.1.0 Tweaks and new features
Closed this issue · 0 comments
Pe8er commented
Blockers
- Finalize firmware
- Confirm that keycaps fit (wait for the prototype to arrive)
- Fix power switch and battery connector
- Rewire the whole bloody thing
- Bottom plate holes for battery connector
- Increase vertical switch spacing by 0.5mm so that wrk caps don't rub against each other
Important
- Go back to the schematic and clean it up
- Update MCU footprint to nice!nano
Bullshit
- Add teardrops
- Make footprints more descriptive: battery connector
- Graphics on the bottom plate?
- Different logo?
- Add rubber feet markings
- Make footprints more descriptive: diodes
-
Figure out a push type of power switch and position it opposite of reset button