Upload error on FlyingBear Ghost 5
nfalco79 opened this issue · 1 comments
Plugin Version
1.4.1
Cura Version
5.1.0
Platform
Windows 10
Printer
Flying Bear Ghost 5
Reproduction steps
After setup MKS plugin and connected to the printer I can see in Monitor tab Heat temperatures and commands "Move to Home" are executed correctly by the printer.
I have used the default printer setting shipped with Cura. No changes.
Actual results
When I load this file with Ultimaker Cura directly to the printer it fails immediatly on 0% and on the printer I see "Upload error"
Expected results
I expect the printer start the job
Checklist of files to include
- Log file
Additional information & file uploads
The problem appears to be caused by the absence of the SD card in the printer slot when printing via WiFi.
Perhaps unlike normal printers that have a memory buffer of a few MB, the 3D printer uses the SD card as memory to save work sent via WiFi and then print it.
Coincidentally the SD card was in the slot when I sent an image and the print started. I then noticed that the SD card contains the file I had sent to the printer.
@Elkin-Vasily I would like to suggest the plugin have a Tips on MKS setup page or when "Upload error" is returned than show a message such as "Make sure the SD card is in the printer and retry"