QIDITECH/QIDI_PLUS3

Issues

• Mainboard and toolhead board pinouts

  #34 opened 6 months ago by vega-d
  1

• Fans in fluidd interface

  #15 opened a year ago by next-comp
  3

• XPlus 3 is abandoned?

  #33 opened 6 months ago by Bonnyfede00
  1

• Z offset still is not saving

  #32 opened 6 months ago by JozephSchmoe
  1

• Z-Offset not saving

  #16 opened a year ago by defiante
  4

• Wifi Password-length is artifically limited

  #31 opened 8 months ago by DanielH1987
  6

• Stepper Motor Specs for TMC Driver Value Tuning

  #30 opened 8 months ago by NightHammer1000
  9

• Firmware Based on newer Klipper Version

  #27 opened 8 months ago by NightHammer1000
  52

• Fluidd Gcode Viewer

  #18 opened a year ago by ADRS55
  7

• Amend bed mesh levelling to wait for a couple of minutes after getting the heated bed up to temperature

  #23 opened 10 months ago by HostileThuggery
  2

• Provision of HMI files

  #28 opened 8 months ago by leadustin
  4

• Board Serial Console over USB TTY Adapter

  #29 opened 8 months ago by NightHammer1000
  1

• Support cold-pull cleaning

  #25 opened 9 months ago by jrice128
  1

• Why not heating bed and nozzle at same time?

  #26 opened 9 months ago by majo1604
  2

• HTTP 500 error

  #24 opened 9 months ago by wingman399
  2

• Rename chamber temp/heater

  #11 opened a year ago by Emetz564
  1

• Add Spoolman Support

  #20 opened a year ago by Senorgif2
  8

• No wifi \ aic8800 drivers after flashing xindi-20230309.img

  #22 opened 10 months ago by lucymorn
  5

• Can't update firmware after flashing xindi-20230309.img on a new 32GB EMMC

  #21 opened 10 months ago by lucymorn
  10

• file transfers to x-plus3.

  #17 opened a year ago by WiskyBlackOut
  5

• Filament replace button behavior

  #19 opened a year ago by ADRS55
  2

• Input Shaper

  #13 opened a year ago by pganns
  1

• firmware update problem

  #9 opened a year ago by vojd11
  4

• Rename borad Fan to Board Fan

  #12 opened a year ago by pganns
  1

• Checksum Error with 4.2.12

  #8 opened a year ago by ArnaudSibille
  1

• New firmware corrupt

  #7 opened a year ago by emudem
  3

• Ther is no Downlod Image for V 4.2.12

  #6 opened a year ago by lorangthierry
  7

• Bed Levelling Error

  #4 opened a year ago by peterle-k
  1

• Code for new releases not available

  #3 opened a year ago by stew675
  2

• Add 0.005 or lower option for Z offset

  #2 opened a year ago by Lightning2X
  1