Features list:

Single/double/tripple/quadriple/many_x/hold&release
Touchlink reset
ONOFF bind
Level control bind
Bindings configuration
Remote reset

How to join:

Press and hold any button for 3-10 seconds(depends whter or not device is on a network), until device start flashing led
Wait, in case of successfull join, device will flash led 5 times
If join failed, device will flash led 3 times

How to use touch link

Deprecated due to memory issues, you can use FREEPAD_ENABLE_TL macros if you want to compile with TL functionality

What's button mapping?

How to add device into zigbe2mqtt

Should be already in dev branch (as of 19-05-2020)

Work modes

By default remote works as custom swith, with multiple clicks, this behaiviout has own drawback. In order to detect multiple clicks, remote sends commands with 300ms delay. You can change this behaviour by cost of double/tripple/etc clicks. To do that you need to change

ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG cluster ATTRID_ON_OFF_SWITCH_TYPE attribute

Values are:

ON_OFF_SWITCH_TYPE_MOMENTARY (0) -> no delay, but no multiple clicks, only single

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '0'

ON_OFF_SWITCH_TYPE_MULTIFUNCTION (2) -> 300ms delay, full set of clicks

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_type" -m '2'

ONOFF cluster binding

By default command is TOGGLE, but you can change this behaviour

Change ZCL_CLUSTER_ID_GEN_ON_OFF_SWITCH_CONFIG clusters attribute ATTRID_ON_OFF_SWITCH_ACTIONS

ON_OFF_SWITCH_ACTIONS_ON

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '0'

ON_OFF_SWITCH_ACTIONS_OFF

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '1'

ON_OFF_SWITCH_ACTIONS_TOGGLE (default value)

mosquitto_pub -t "zigbee2mqtt/FN/BUTTON_NUM/set/switch_actions" -m '2'