Bigtreetech SKR 1.3 Connection issue

[blueeagle69]

Hi.

I have changed the baud rate of the Resumer3D to match that of the new board, but despite that, it simply refuses to connect to my new board.
The SKR connects to my computer (host software fine).
I have Marlin 2.0 bugfix installed on the board.
I am currently running the 1.1.4 firmware.
Is it worth trying the 1.1.5 beta?
Many thanks.
Update
Just flashed the 1.1.5 beta, but no luck.
The flashing slows down like it's trying to connect, but doesn't, and just repeats the process.
I changed the baud rate back down to 115200 to match my previous Anet board and it connected as normal 😢
Any help would be appreciated.
Thank you, once-again.

[blueeagle69]

Any updates? 😢

[hackaday3D]

Hello blueeagle69, so sorry for delay replay, can you tell me the usb driver chip on the skr board? and use the toolbox to capture the log and send to me ?

[blueeagle69]

Hi. It appears it doesn't have a USB driver chip, it goes directly to the MCU. https://m.facebook.com/groups/505736576548648?view=permalink&id=813987329056903

…

On Thu, 21 Nov 2019, 07:44 robert, ***@***.***> wrote: Hello blueeagle69, so sorry for delay replay, can you tell me the usb driver chip on the skr board? and use the toolbox to capture the log and send to me ? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#13?email_source=notifications&email_token=ACMASZEB64O343SRAJS6UATQUY35ZA5CNFSM4H2VFZA2YY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOEEZI5EI#issuecomment-556961425>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACMASZHLDGHBL4OBTQDQ3OLQUY35ZANCNFSM4H2VFZAQ> .

[blueeagle69]

Do you mean the BoxTool?
Could you brush me up on collecting logs, I've totally forgotten!

[cinealfa]

any luck?