Python scripts I implemented for my Conrad Advent calendar :)
I use a RaspberryPi 3 for this project.
Other models should work fine but you must check for correct wiring.
Display, keyboard, mouse, and an audio device are indispensable.
- Raspbian Stretch
- Python 3
- Scratch 1.4
- GPIO Zero 1.4.0
sudo apt install python3-gpiozeroorpip install gpiozero
- Raspberry Pi GPIO 0.6.3
sudo apt install python-rpi.gpioorpip install RPi.GPIO
- Day 1
- Day 2
- Day 3
- Day 4
- Day 5
- Day 6
- Day 7
- Day 8
- Day 9
- Day 10
- Day 11
- Day 12
- Day 13
- Day 14
- Day 15
- Day 16
- Day 17
- Day 18
- Day 19
- Day 20
- Day 21
- Day 22
- Day 23
- Day 24
This Advent calendar was somewhat disappointing.
Most of the gifts were simple jumper cables or pin headers and there are quite some mistakes in the manual.
Without some kind of mount for the servo motor each task with it was very annoying.
Some resources are only with a prior registration available.
It's probably a fun project for children or novice users but not for an experienced tinkerer.