SpaceTeam/STS1_EPS

Issues

• EPS 3.0 Issue collector

  #31 opened 3 months ago
  0

• Labels of panel connector are incorrect

  #28 opened 3 months ago
  1

• Board2 TPS2420RSAT max IO port input voltage

  #27 opened 3 months ago
  1

• Board2 Fuse F1 missing value

  #26 opened 3 months ago
  1

• Mixed ISO and ANSI Logic Gate Symbols

  #25 opened 3 months ago
  1

• Board2 logic supply same issue as #20

  #24 opened 3 months ago
  1

• Board2 Capacitor Bank Values missing

  #23 opened 3 months ago
  1

• Mark all "bypass" resistors DNP

  #22 opened 3 months ago
  1

• Board2 D2 missing value

  #21 opened 3 months ago
  1

• LTC4451AV ~{SHDN} on U28

  #20 opened 3 months ago
  1

• Define tolerances for all critical resistors

  #19 opened 3 months ago
  1

• Define tolerance for current limiting resistors on TPS259472ARPW

  #18 opened 3 months ago
  1

• TPS259472ARPW for UART?

  #17 opened 3 months ago
  1

• Label naming confusing

  #16 opened 3 months ago
  2

• D12,14,15,16,17 missing value

  #15 opened 3 months ago
  1

• Check if there is a better solution for the inter-EPS connectors

  #13 opened 4 months ago
  0

• Align PCB to new axis orientation

  #10 opened 4 months ago
  0

• Alter deployment switch design, so that deployment switches also work, if there is no battery power.

  #9 opened 4 months ago
  0

• Check signl to deployment timer (Q4)

  #8 opened 4 months ago
  0

• Try to use other connector to the side PCBs

  #7 opened 4 months ago
  0

• Disconnect batteries from bus when voltage drops below a certain threshold

  #6 opened 4 months ago
  0

• Implement protection against over discharging

  #5 opened 4 months ago
  0

• UCI COBC_3v3 is connected to ground

  #4 opened 4 months ago
  0

• Check footprint of EPS2 U27

  #3 opened 4 months ago
  0

• Change connector to battery so it is easier to assemble

  #2 opened 4 months ago
  0

• Trace from battery transistor to VOUT is much to small

  #1 opened 4 months ago
  0