Example of how to use the RTT Logging based on the original blinky example from the nRF5 SDK v14.2.0 from Nordic Semiconductor.
Open the example like all the other ones from the official SDK using Segger Embedded Studio.
Once you have plugged your board,open two terminals and run the following commands :
- Terminal #1 :
JLinkExe -device NRF52 -if SWD -speed 4000 -autoconnect 1
- Terminal #2 :
JLinkRTTClient
You can then proceed and Upload and Run the example onto the board.
- Board NRF52DK
- SDK v14.2.0
- Segger Embedded Studio Release 3.30
- Segger J-Link v6.22a
Feel free to submit issues and enhancement requests.