Issues
- 0
Add solution for solar panel charging
#26 opened by Strooom - 0
add solution for Li-Ion 3.7V battery
#25 opened by Strooom - 0
- 0
- 1
check if we could use different EEPROM
#22 opened by Strooom - 1
Check UART Rx and Tx - UART1 & UART2
#19 opened by Strooom - 1
check annular ring for USB THT pins
#18 opened by Strooom - 1
Check impedance for RF output
#17 opened by Strooom - 1
Add solder bridges to disable battery charging when using non chargeable cells..
#11 opened by Strooom - 1
Relocate SPI CS
#16 opened by Strooom - 1
Adjust PCB width to center ePaper display
#15 opened by Strooom - 1
Add 100n decoupling to MCU - RESET
#13 opened by Strooom - 1
Swap UART1 and UART2 pins
#14 opened by Strooom - 1
Extend debug port connector with extra signals
#12 opened by Strooom - 1
Correct decoupling capacitors in BOM
#9 opened by Strooom - 1
Correct ePaper display reset
#10 opened by Strooom - 1
Adjust pad size for test-pads
#8 opened by Strooom - 1
Move PB3 to debug port for TRACESWO
#7 opened by Strooom - 1
- 1
rename KiCad project library
#2 opened by Strooom - 0
Think about solution for sensors that require 5V, eg Sensirion PM sensor, CO2 sensor, ...
#21 opened by Strooom - 0
Check which logo's we want on th PCB silkscreen
#20 opened by Strooom - 1
Add stictching VIAs
#5 opened by Strooom - 1
Improve D-/D+ trace properties
#4 opened by Strooom - 0
Check values for ePaper driver
#6 opened by Strooom - 0