AgIrrigationRemoteControl

Control an Ag Industrial 3-Phase Irrigation Pump with Arduino UNO and XBee RF

Overview

A solid rural 2-Mile range; possibly more ( 900MHz @ 1/4-Watt Transceiver )
No cellular, FCC liscensing or any other charges; Just hook it up and use
One Hand-Remote can control multiple irrigation pumps
Multiple Hand-Remotes can control one irrigation pump
Uses Pump Panels "AUTO" selection; doesn't disturb Manual Hand-Off & Start sequences
Implements a "stay-off" after a power loss that is required by power companies
Hand-Remote has settable Alarms that signal (via buzzer) unexpected conditions such as:
- Power not as expected ( Alarms when pump shutdown has occured by a power loss )
- Water Pressure ( if equipped ) for when a hose falls off
- Ditch Water Level ( if equipped ) too high or low
Simple expansion of a digital pressure gauge for water pressure monitoring
Simple expansion of an Ultrasonic distance meter for water level monitoring

I'll be building a few of these units complete with

(1) Hand-Remote; Custom programmed to your irrigation setup
(1) Pump-Controller; Custom programmed to your irrigation setup
(1) Installation Kit including:
- The required 480VAC 3-phase Power Supply
- A 480VAC or higher Solid State Relay for Motor Starter Control
- 600V THHN Hook-Up wire required to Motor control installation

If you'd like to purchase just a single unit or the Water-Level and Pressure expansion kits; you can email me directly at tgit28@gmail.com