/motion

DIY Zigbee CC2530 Motion sensor (AM312/ AM412/ BS312/ BS412), Temperature /Humidity /Pressure sensor (BME280), Ambient Light sensor (BH1750), Magnet sensor, Light Dependent resistor (LDR)

Primary LanguageC

How to join:

If device in FN(factory new) state:

  1. Press and hold button (1) for 2-3 seconds, until device start flashing led
  2. Wait, in case of successfull join, device will flash led 5 times
  3. If join failed, device will flash led 3 times

If device in a network:

  1. Hold button (1) for 10 seconds, this will reset device to FN(factory new) status
  2. Go to step 1 for FN device

Hardware

2AAA version

  • Gerber, BOM, Scheme 2AAA

CR2 version

  • Gerber, BOM, Scheme CR2
  • Attention! Do not use CR2032 and CR2450 with a motion sensor (AM312 / BS312), as at low battery voltage (<3v) false alarms occur.

Firmwares

  • Settings can be changed without restarting zigbee2mqtt

  • Bind

  • Converters

Thanks for the help