Details and helpful files for the Signum 3 adjustable ergonomic mechanical keyboard
- Pinky columns too low
- Supports overall finger column height adjustment, but not really so for individual finger height
- Issue with the 1/3u footprint spacing
- Reduce separation to, around less than 1/6 and confirm movement within the scope of general finger length (IE: Increasing height on pinky column should not raise the column higher than ring finger column)
- Correct cutting paths
- Bottom left router edge
- Upper right arc bulge overtravel
- OLED screen
- LOL
- Nano controlled
- Rotary+click dial menu interface
- Pomodoro display and menu management
- Screensavers
- Calculator???
- Pro Micro support
- Cover for exposed MCU (AKA: Mt Dew shield)
- alternate mount location for MCU reset button
- Number row (optional but supported)
- Correct silk screen locations
- Correct triple switch footprint silk screen borders, and make two sided
- Correct Diode polarity print to not be overlapped by SMD footprint
- Add M2 (case) mounts on corners
- USB wire mounts for teensy connector bypass
- Annoy-otron 5k
- AKA Pomodoro interrupter
- Counts down pomodoros
- Counts UP wasted time on unacknowledged time expirations
- Beeps with PCB mount speaker
- Vibrates keyboard with mounted motor?!?!
- Figure out a way to shut off input so you CAN'T continue working?
- Mini USB hub (header mounted with paths to optional USB A female ports)
- Requires wire mount for bypass teensy plug to hub rather than wire mounts
- Parts are iffy, or board mount full circuit and SMD solder (cost bump)
- Alternative switch locations (duplicates)
- Bottom keys 2 and 3 in from the corner keys
- Map to additional optional 3rd thumb key
- Map to 3.5mm mono pcb mount jack (footpedal?!)
- Hinge-ability, Plico style
- How tho? PCB mount slip ring and brushes?
- Alternative split angle support
- Full Split support with QMK and pro micrii?