Voron0 Waveshare 3.5" Display Mount

This mod will allow you to mount a 3.5" Waveshare on a Voron 0 so that you can use KlipperScreen.

Image 1

BOM

  • 3.5" Waveshare screen
  • 4 M3x6 screws (Fasten front mount to back mount)
  • 2 M3x6 screws (Fasten mount to frame)
  • 2 M3x6 screws (Fasten 2 skirt parts to frame)

NOTE

The parts are in the recommend print orientation.

Installation

  • I created a wiring harness to connect the following pins from the Pi (I'm using a Pi Zero 2 W) to the display: Image_1
  • Insert the screen into the front part
  • Line up the back part and fasten with 4 M3x6 screws
  • Line up the screw holes on the mount to the nuts in the bottom extrusion of the frame
  • Fasten the mount with 2 M3x6 screws
  • Fasten the 2 skirt parts to the frame.
  • Profit

Images

Image 1 Image 1 Image 1