X-Rail mount step doesn't say it's mounting to X-Rail
mobilemcclintic opened this issue · 0 comments
mobilemcclintic commented
On Page 29, the manual shows putting (4) M3x6 BHCS into the holes that mount to the X-Rail carriage. Right after that, it notes about installing the X end stop magnet. In my mind, I'd install the magnet when the assembly is off the machine, so I was dropping screws as I was glue and pressing the proximity magnet in.
Maybe it should have a picture of the X-Rail carriage in the image so it's explicitly shown that it is being physically connected to the machine. Maybe it's just me.