VoronDesign/Voron-Tap

Questions Regarding the Use of Voron-Tap

leeeboo opened this issue · 2 comments

leeeboo commented

Hello,

I've recently started using Voron-Tap and I have a couple of questions that I hope the community can help answer.

  1. Does residual filament on the nozzle affect the z-offset? If so, how can this issue be addressed?
  2. I tend to apply adhesive on the print bed during printing. Will this have any impact on the printing process?

I would appreciate any insight or advice on these matters.

Thank you!

TheFuzzyGiggler commented

1.) It will change your z-height but since the tap sensor is relative anyways it shouldn't affect it much unless the residual filament gets dislodged while running your homing macro. What I mean by relative is, that the Z height will be offset for every probe as long as that residual filament is attached. You should be rehoming between prints anyways so it shouldn't be a major issue.

2.) Nope, except you might get some adhesive on the nozzle where it taps the bed during probing. But I don't think that will be an issue really.

leeeboo commented

@TheFuzzyGiggler Thank you so much!