/XR-HRTF-capture

XR-based HRTF Measurement Control App

Primary LanguageC++

XR-based HRTF Measurement Control App

This app is designed to be used as a part of the XR-based HRTF Measurement System.

Supported Hardware

  • Tested on Windows with RME Fireface UC using ASIO Drivers.
  • Other platforms/interfaces should work, altough haven't been tested.

Getting Started

  • Installation
    • Compile from source:
      • Get JUCE.
      • ASIO SDK header files can be obtained from Steinberg.
    • Or download the latest executable from the Releases page.
  • Usage
    • Make sure that the Quest is on the same local network as the PC and its running the XR Interface App.
    • Input the IP address displayed by the XR app and click Connect OSC.
    • Load a Subject Folder. A template Subject Folder named YYYYMMDD-XR-SUBJ000 can be found in Resources.
    • Adjust Output Level:
      • Start with a low value eg. -40 dB and gradually increase to a considerable level.
      • Test sweeps can be triggered by clicking Reference and HP EQ buttons.
    • The app is ready to run measurements.