Accumulator Pattern Practice

The following is an opportunity for you to practice using the accumulator pattern.

Project setup

Getting started

Fork and clone this repository.
Navigate to the cloned repository's directory on your command line. Then, run the following command:
```
npm install
```
This will install the libraries needed to run the tests.
Open up the repository in VSCode. Follow the instructions below to complete the Lab.

Tests

To run the tests, you can run the following command from the command line. You will need to be in the root directory of your local directory.

npm test

This will run the test output once.

Test watcher

If you'd like, you can have the tests run constantly. This means that each time you save your file, your tests will re-run. To do so, you can run the following:

npm run watch

Follow the on-screen prompts to exit out of the constant runner.

Run test files individually

There are a lot of tests that are contained in this project. You can run a single test file individually by putting the name of the file after npm test. You can even only put part of the file name.

npm test strings

Run tests individually

After choosing a specific file to run, you can also specific which test you want to run, specifically. Add .only after either test or describe for the specific test you'd like to run.

test.only("should return an array of everyone's name who is in the line, in order", () => {

This will either run the specific test or, in the case of adding .only to a describe, all of the tests for a specific function.

NOTE: Don't forget to remove this after you get the test to pass!

Run file

If you want to manually test out your file, you can do so by running the following command.

node index.js

The output will be printed to your terminal.

a-n-g-i-e-r-i/resource-accumulator-pattern-practice