This is an example application that demonstrates how to use Rust, Tokio and Axum to build a web server on the ESP32-S3 microcontroller.
You'll need tools:
espup
- a tool to install the ESP32 toolchain and other toolscargo-espflash
- a tool to flash the ESP32
cargo install espup cargo-espflash
espup install
- Set the WiFi credentials as environment variables. They will be baked into the executable at build time.
WIFI_SSID
WIFI_PASS
- This command builds the project and flashes it to the ESP32-S3:
cargo espflash flash --release --monitor
Once the ESP32-S3 is connected to your network, it displays the IP address on the serial console. The server runs on port 80.
$ curl http://192.168.0.24/state | jq
{
"counter": 940,
"free_heap": 216452,
"ip_address": "192.168.0.24",
"mac_address": "DC:DA:0C:2A:26:C8",
"message": "Hello from ESP32!"
}
I mean, this is strapping rockets to a bicycle.
It works if you don't overload it. The ESP32-S3 is a microcontroller with limited resources. The web server can only handle a few requests at a time before it runs out of memory.
- 5 concurrent requests
- 50 requests per second
If I go over ~5 concurrent requests, IDF runs out of memory and crashes.
Axum wasn't designed for microcontrollers to put it mildly. It's actually a miracle it works at all. I did this for science. We do what we must because we can.
Besides Axum, Warp also works. It uses somewhat less memory, so you can maybe throw a few more requests at it.
At the time of writing this, Rocket and Actix-web don't work since they require Tokio's rt-multi-thread
feature which doesn't compile on EPS32 yet.
Honestly, just use MQTT or something. It's a microcontroller, not a server.
See .cargo/config.toml
for the list of supported chips. Set the target
to the chip you're using.
This project is heavily inspired by Sami J. Mäkinen's esp32temp. Thanks for figuring out how to make this work!
Whatever.