mpmd bed chock
A set of small chocks prevents the print bed from tilting while printing on the Monoprice MP Mini Delta 3d printer.
3D PRINTING
Three (3) chocks are required. Suggested parameters for 3D printing:
layer height: 0.050mm
first layer height: 0.200mm
perimeters: 3
bottom solid layers: 10
top solid layers: 15
fill density: 25%
HOW TO USE
At the start of each print: after the printer performs its calibration "bed taps", gently slide the three (3) chocks in place under the bed at each of the switches. This should prevent the bed from tilting.