This is a simple bootloader builder for Libre Computer boards.
sudo ./setup.sh #install pre-requisites via apt
git clone --single-branch --depth 1 https://github.com/libre-computer-project/libretech-builder-simple.git
./build.sh BOARD_TARGET # eg. ./build.sh roc-rk3399-pc
The default output directory is out/ and is set by LBS_OUT_PATH in configs/build.
The default board bootloader target is for MMC boot. The output bootloader needs to be written to the correct disk sector.
For boards with SPI NOR, there is a separate board bootloader target ending with -spiflash. To flash SPI NOR, dump the output image to a MMC device and the board will boot and flash the SPI NOR.
sudo dd if=out/BOARD_TARGET-spiflash of=/dev/null bs=1M
Replace "BOARD_TARGET" and "null" to the proper file and block device respectively. Be careful not to overwrite the wrong block device!
To configure u-boot, set LBS_UBOOT_MENUCONFIG=1.
- ALL-H3-CC-H3
- ALL-H3-CC-H5
- AML-S805X-AC
- AML-S905X-AC
- AML-S905X-CC-V2
- AML-S905D-PC
- ROC-RK3328-CC
- ROC-RK3328-CC-V2
- ROC-RK3399-PC
ARM Trusted Firmware Documentation ARM Trusted Firmware Design