As of July 2021, AWS EC2 instances can be assigned IPv4 and IPv6
address prefixes. The IPv6 prefixes are /80, which gives your EC2 instance
281,474,976,710,656 IP addresses to play with. You could use the feature to
run 281 trillion containers with their own IPs (which I assume is what AWS
intended for the feature), but I wanted to find a more fun use.
SSH doesn't support TOTP (those six digit codes that change every 30 seconds) out of the box. Neither does Telnet, plain old HTTP or any number of protocols. So I thought it would be fun to add TOTP support to every protocol by embedding the six digit code inside the IP address.
Generate a QR code and shared secret using the generate/generate command. Use
that QR code with an app like Google Authenticator and keep the shared secret for
usage later.
Start an EC2 instance in an IPv6-enabled subnet:
aws ec2 run-instances \
--instance-type m6g.medium
--min-count 1 \
--max-count 1 \
--key-name $KeyName
--image-id resolve:ssm:/aws/service/ami-amazon-linux-latest/amzn2-ami-kernel-5.10-hvm-arm64-gp2 \
--network-interfaces SubnetId=$SubnetId,Ipv6PrefixCount=1,DeviceIndex=0,Groups=$SecurityGroupId
On that instance run the following commands to enable IPv6:
mac=$(curl http://169.254.169.254/latest/meta-data/network/interfaces/macs/)
prefix=$(curl http://169.254.169.254/latest/meta-data/network/interfaces/macs/${mac}ipv6-prefix)
ip route add local $prefix dev eth0
ip addr add local $prefix dev eth0
Now you can build the ghost ship:
sudo yum install libnetfilter_queue-devel
go build
sudo setcap cap_net_admin=+ep ipv6-ghost-ship # this means it can run without sudo
Now create an iptables rule to only allow incoming connections to IP addresses
that are permitted by ipv6-ghost-ship:
ip6tables -A INPUT -p ip -m state --state NEW -j NFQUEUE --queue-num 0
Start the ghost ship:
./ipv6-ghost-ship --secret AZCHNJHC42T3PCHNLQPJAEBMFLEXAMPLE
Now from your local computer, try ping6 or ssh or anything. If your EC2
instance was assigned the prefix 2406:da1c:176:a202:ee3f/80 and your
authenticator app currently says the code is 123456, then you would run:
ssh ec2-user@2406:da1c:176:a202:ee3f:12:34:56
# ^ this is where the magic happens
You will connect successfully! If you try that again a minute later, no such luck. If you had tried any other suffix on that IP address, your connections will also be dropped.
Because Massimo implied I wasn't clown-ish.