/vive-diy-position-sensor-geometry-getter

Small program to generate base station geometry for vive-diy-position-sensor project

Primary LanguageC++

vive-diy-position-sensor-geometry-getter

Small console program to generate base station geometry for vive-diy-position-sensor project.

How to use

  1. Download both openvr_api.dll and vive-diy-position-sensor-geometry-getter.exe from release page.
  2. Make sure SteamVR is setup and running on your computer, with Room Setup done successfully.
  3. Run vive-diy-position-sensor-geometry-getter.exe. It should print two lines like shown below (with your data of course). Save these lines and use them to configure your Teensy.
b0 origin -1.528176 2.433746 -1.969393 matrix -0.839498 0.340747 -0.423244 -0.041220 0.736752 0.674906 0.541798 0.584028 -0.604456
b1 origin 1.732790 2.514255 0.709026 matrix 0.454144 -0.645781 0.613776 0.026748 0.698489 0.715120 -0.890527 -0.308350 0.334488

Compilation from source

Just open in Visual Studio and build. Be sure to have openvr project cloned side-by-side with this one.