Heater times out
craigdavidfox opened this issue · 3 comments
craigdavidfox commented
Could just be my machine doing funny things but I’ve had “heater timed out” a few times, usually when I am changing filaments.
alexqzd commented
Does the button to reheat work after the timeout?
craigdavidfox commented
If I recall correctly, you continue or cancel then it goes to a reheat screen and you press the continue button.
I have been away form my printer for a bit so I'm not 100% sure on the exact steps after it timesout.
I have a better understanding on how thermal overload is run now and perhaps that is kicking in now, the system is sitting idle and maybe it's protecting itself.
alexqzd commented
Yes, it is normal to get a timeout after a couple minutes of being idle in the filament change screen