/0xB2

Pro-Micro/Elite-C replacement with RP2040 and USB-C

OtherNOASSERTION

0xB2 - splinky

Pro-Micro/Elite-C replacement with USB-C and RP2040.

Designed for use in custom mechanical (split) keyboards, but many other uses are possible.

Splinky v2

Features:

  • Pro-micro / Sparkfun RP2040 compatible footprint, with 5 extra pins at bottom (Elite-C style)
  • Raspberry Pi RP2040 MCU
  • Up to 16MB flash memory (depending on component selection and availability)
  • User LED & USB VBUS detect
  • Low profile USB-C mid-mount connector
  • Designed to be manufactured and assembled by all common PCBA services (including JLCPCB)

Pinout

The pinout is compatible with the widely available SparkFun RP2040, with extra GPIO12..16 pins broken out on the lower side.

USB VBUS detection on GPIO19.

This pinout is a de facto standard, established by actors of the MK community (see discussions in #RP2040 on the bastardkb Discord server)

Additionnaly, a user LED is tied to GPIO17, can be used for UF2 bootloader status indication, or any other purpose (or turned OFF, no annoying always-on power LED).

Programming

The splinky uses a basic two-button reset circuitry.

In order to put the board in bootloader mode, press briefly the RESET button (marked R) while holding the BOOT button (the second one). If the buttons are not reachable (soldered upside down), the /RST pad can be shorted to GND, while the two smaller BOOT pads (next to D8) are maintained shorted (v2 only).

Manufacturing

Releases contain required information (gerbers, bom, pos) for assembly by JLCPCB.

Releases

  • v3 updated pinout - current release
  • v2 first public release
  • v1 first prototyping run

Credits