Issues
- 0
- 5
Release 1.9 makes screen flicker
#73 opened by bartv - 1
Add BOM to PCB folder
#94 opened by meetmrhung - 1
Adding serial command
#97 opened by Ralim - 4
- 1
Low Flash Space
#95 opened by Ralim - 1
- 7
- 3
monitor command overflow?
#63 opened by staze - 8
Pulsing current draw
#85 opened by tzanetos - 2
New serial command output
#91 opened by knarfS - 0
- 3
Left Hand Voltage Display garbage
#89 opened by nealzip - 4
Set current <1A off after calibration
#84 opened by danielbriggs - 1
Resistance readout in display doesn't work
#72 opened by knarfS - 2
Display of ohms when current set to zero
#88 opened by raivisr - 0
Encoder Push Button Debounce
#82 opened by danielbriggs - 1
- 2
Feature Request - Discharge Timer
#77 opened by msrhs - 4
Always calibrate from factory settings
#51 opened by Arachnid - 6
Setpoints below ~1A seem out?
#74 opened by projectgus - 0
- 4
- 0
Add dev guide to the wiki
#76 opened by Arachnid - 0
Add the 'gold' bootloader ROM to the repo
#75 opened by Arachnid - 0
Improvement of the serial ok responses
#70 opened by knarfS - 0
Missing serial command undervolt
#69 opened by knarfS - 5
Current sequence
#67 opened by knarfS - 0
External current set
#68 opened by knarfS - 0
Serial commands get lost
#66 opened by knarfS - 1
Duplicate "h" in mAh display
#62 opened by staze - 1
Current not set correctly when monitoring
#64 opened by knarfS - 5
- 1
Add "reset to 0" menu item
#44 opened by andreiav - 3
- 1
suggestion for better usability: add load on/off menu item as first line
#58 opened by gunthervermeir - 1
Current not 0 after undervolt cutoff
#40 opened by dl2sba - 2
Measured voltage decreases with current
#55 opened by Arachnid - 1
Add "quit" to the serial interface
#53 opened by andreiav - 1
Stable display reading
#33 opened by dl2sba - 1
Bigger steps when rotating the encoder while pressed
#43 opened by andreiav - 1
Knob debouncing needs improvement
#48 opened by limpkin - 0
Undervolt condition reported as OVERTEMP
#39 opened by dl2sba - 1
display bug in menu
#49 opened by limpkin - 10
Software feedback loop induces oscillation
#36 opened by Arachnid - 1
USB Interface Commands
#38 opened by bluepup - 0
Explicitly initialize global variables
#42 opened by raivisr - 4
After low voltage cutoff power should be displayed
#35 opened by dl2sba - 3
Display goes blank at cutoff voltage
#34 opened by dl2sba - 1
Left display corrupted
#32 opened by dl2sba