PI1541pcb

This is a PCB based on the Steve White schematic. You just plug on the top of a RPI 3 and you have a fully working 1541 disk emulator :). You can access to the original article from here https://cbm-pi1541.firebaseapp.com/.

Note

This is a work in progress, several testing must be made but it should work as is. I take no responsibiltiy for any damage to any equipment that results from the use of this board. USE AT YOUR OWN RISK!

If you like the project or want to support it, you can buy me a beer or a KO-FI :)

Parts required

This PCB :)
There is two ways to connect to the C64, one is solder a DIN 6 connector for PCB and use a male 2 male cable or solder 5 cables on the other connector available on the pcb and use only a male connector on the top.
Level shifter board for Arduino (https://www.ebay.com/sch/i2c+logic+converter+module)
Female 2x20 2.54 connector (to plug this pcb on top of the Raspberry Pi 3)
2 x 330 ohm resistor + 0805 led smd. (not required) (power and activity led)
5x switch-omron (B3F-31XX)
128x64 Oled screen (not required).
5v Passive buzzer (not required).
3x separators for Raspberry Pi (it not required but recommended since the gpio connector already keep the pcb from bending).
A Raspberry Pi 3 :)
Plug the board on top of the RPI3. Then follow the instruction that Steve comment on his article.