This implementation conflicts with SMBus specification

Today I ran into an issue while implementing a PMBus interface on an Arduino every.
PMBus derrives from SMBus which uses I2C and ultimately TWI.

From System Management Bus Specification Version 3.3:

This requires a 0 byte read or write transaction where the read is currently not possible with this implementation as the write bit is implicitly set in both cases.

Both cases result in a call to

uint8_t TWI_MasterWriteRead(uint8_t slave_address,
                         uint8_t *write_data,
                         uint8_t bytes_to_write,
                         uint8_t bytes_to_read,
						 uint8_t send_stop)

with bytes_to_write and bytes_to_read both being 0.

In this case the function always sets the write bit:

else if (master_bytesToWrite == 0 && master_bytesToRead == 0) {
			twi_mode = TWI_MODE_MASTER_TRANSMIT;
			uint8_t writeAddress = ADD_WRITE_BIT(master_slaveAddress);
			TWI0.MADDR = writeAddress;
		}

Am I missing something here? Or did somebody want to save a few lines, not having this special case in mind?

ArduinoCore-megaavr/libraries/Wire/src/utility/twi.c

Line 322 in 5e639ee

else if (master_bytesToWrite == 0 && master_bytesToRead == 0) {

Hi @tamebits ,
that piece of code is tackling one shortcomings of Wire APIs, that the only way to scan the bus is the pattern

Wire.beginTransmission(address);
if (Wire.endTransmission() == 0) //device found

A solution would be to keep track of the user intention and just set the write bit in this particular use case.
If you want to provide a PR I'll be glad to review it!