This repository contains the various configuration files I use for the various ESPHome devices I have and use around my home.
The fairfield and waltham directories contain the various device configurations.
The resources directory contains resources/assets (fonts, images, etc.) used by the various configurations.
The shared directory contains source code and configuration files shared/used by multiple device configurations.
The dev directory contains various device configurations that I use(d) to test stuff. These are not actively maintained and may or may not build and/or work.
The only necessary file that is not here is shared/esp__common_secrets.yaml; an example is provided, instead. If renamed and updated with appropriate values, all the code here will compile and run.
See the CSC.md document for information regarding the Climate and Sprinkler Controller configurations.
The other configurations are fairly self-explanatory and probably don't need an entire document to themselves. Still, here's quick rundown:
esp-rc-ir-front-room.yamlandesp-rc-ir-bedroom.yamlare configurations I use with a couple of IR Blasters I have set up for remote control of various other devices I have around.esp-lights-*.yamlare configurations I use with my LED Strip Controllers for control of various LED lighting I've installed.esp-sensor-*.yamlare configurations I use with my sensor boards for monitoring the temperature and humidity in various locations around my home.esp-snowflake-controller.yamlis a device I use to remotely control my snowflakes.
This is a project I did based on this guide from Instructables. I made a number of modifications:
- I used APA102 ("DotStar") LEDs because I had them on-hand.
- I wired the strips of LEDs into a single string (as opposed to four).
- I used a D1 Mini (ESP8266) module running ESPHome connected to Home Assistant to allow full remote control of the pieces.
- I redrew the body in Fusion 360 to be a single, multi-part (and consequently multi-material) print. It no longer needs a picture frame to be complete and can be printed a few different ways because of the multiple parts/bodies. My (updated) design is available here. The caveat is that it's less friendly to smaller 3-D printers as it requires a printable area of at least 205x205mm.
That said, the ESPHome configuration bits of interest are:
esp-lights-led-triangles-X.yamlfiles are the base configurations for the displays.esp-lights-led-triangles.yamlis the "real" part of the ESPHome configuration.esp_led_triangles.his the code that renders the display effects I ported from Andrei's repo.esp__common_core.yamlis also imported and required by the HST base configurations (above).
If you found any of this helpful and feel so inclined, please Buy Me A Coffee! ☕️
Thanks for visiting!