This project contains all the necessary software to program the ESP32 microcontroller and interface with it through a Bluetooth API-enabled web browser (Chrome, Opera).
The rs folder contains the source code for the Rust firmware that need to be flashed onto the ESP32. See the
README for instructions.
The src folder contains the source for the Progressive Web App that allows to retrieve the scale's reading in real
time as well as the battery level.
The application is hosted at coffee.beeb.li for convenience of users desiring building the scale.
The app works as a timer to achieve the desired extraction in the desired time. A reference curve is displayed, taking into account the user parameters:
- Coffee Weight: how much coffee grounds were put in the basket (the "Read" button puts the current scale value into this field)
- Target Ratio: the ratio of "coffee out" to "grounds in". The expected output weight is displayed next to the field.
- Pre-infusion Time: this is an amount of time that is added to the timer as soon as >0.5g are detected in the cup. This allows to indicate the desired total brew time including pre-infusion. It's the user responsibility to perform the pre-infusion with this amount of time.
- Total Time: the total brew time, including any pre-infusion.
- The basket or portafilter is put on the scale and tared with the scale's button.
- The desired amount of coffee grounds is put inside the basket
- the basket or portafilter is put back on the scales, thereby measuring the weight of the coffee grounds
- In the Settings pane, the "Read" button next to the "Coffee Weight" input is clicked to read the current value into it
- The cup is placed on the scale and it is tared with the button
- The "Start recording" button is pressed (only available when the scale reads 0g). The app now waits for an increase in weight.
- As soon as the weight exceeds 0.5g, the timer starts counting from the pre-infusion time (default 5s).
- The extraction can be followed in real time and should match the grey reference curve (in a direct drive lever machine , the user would adjust the pressure to match the curve)
- When the extraction is finished, the cup is lifted from the scale, thus stopping the recording.
- Dual-core microcontroller allows for fast sampling rate of the load cell and fast refresh rate of the 128x32 OLED display
- Load cell input is filtered with a Kalman filter for fast response and good smoothing
- The weight is communicated through Bluetooth Low Energy every 200ms
- The microcontroller can charge a LiPo or Li-ion battery and report its charge level
- The web-app persists user settings in the browser's local storage
- Can be added to the home screen of smartphones (e.g. with Chrome on Android, look almost like a native app)
The 3D printable parts are available from the prusaprinters page of this project.
User Nkawu forked part of this repo at the following location: https://github.com/Nkawu/coffee-scale-firmware
This alternative version uses a different microcontroller board and doesn't have any power button, as well as two tactile function buttons.
This project was made possible by the following projects and people (amongst others). Thanks to them!
Distributed under the MIT License