Board to drive a string of WS2801 chips using audio and a MSGEQ7
The FTDI Cable plugs in under the 12v Power Connector. The FTDI Grounds are close to the center of the board, the DTR is closer to the edge of the board.
If the power connector is in the upper right of the board facing up the FTDI pins will be
GND, GND, VCC, RXI, RXO, DTR
- Clone this repo to
~/Documents/Arduino
withcd ~/Documents/Arduino && git clone git@github.com:bguest/AudioLed.git
- Change directory to AudioLED with
cd AudioLed
- Mod setup script
chmod +x setup.sh
- Run Setup
.\setup.sh
this will clone correct versions ofAdafruit_WS2801
andArduino-IRremote
- Download Arduino v1.6.6 (May not compile with later versions of Arduino)
- Launch Arduino v1.6.6
- Open AudioLED
- Set board to
Arduino Pro or Pro Mini
- Set processor to
ATmega328 (5V, 16MHz)
- Verify and Upload Code