ha-stiebel-control

ha-stiebel-control is a ESPhome / Home Assistant configuration to monitor & configure Stiebel Eltron Heating Pumps via a CAN Interface. It requires setting up an ESP32 Microcontroller with a MCP2515 CAN-Tranceiver and some configuring in Home Assistant. It is based on the great work of the Home Assistant community, especially the work of roberreiters and Jürg Müller.

Installation

ESPHome

Set up a new ESPHome Project "heatingpump"
Copy the Content of heatingpump.yaml to the new project
copy the folder stiebeltoolsto your /config/esphome folder (full path should be /config/esphome/stiebeltools)
Change the WiFi Credentials to yours
Change the GPIO Pins under spi and can to your HW configuration

You may want to check/change the CAN IDs of the Manager, Kessel, etc. In order to do so, you have to change them in two places:

stiebeltools\heatingpump.h:

static const CanMember CanMembers[] =
{
//  Name              CanId     ReadId          WriteId         ConfirmationID
  { "ESPCLIENT"     , 0x700,    {0x00, 0x00},   {0x00, 0x00},   {0xE2, 0x00}}, //The ESP Home Client, thus no valid read/write IDs
  { "KESSEL"        , 0x180,    {0x31, 0x00},   {0x30, 0x00},   {0x00, 0x00}},
  { "MANAGER"       , 0x480,    {0x91, 0x00},   {0x90, 0x00},   {0x00, 0x00}},
  { "HEIZMODUL"     , 0x500,    {0xA1, 0x00},   {0xA0, 0x00},   {0x00, 0x00}}
};

heatingpump.yaml: Look for these blocks in the lower part of the file

#########################################
#                                       #
#   HEIZMODUL Nachrichten               #
#                                       #
#########################################
    - can_id: 0x500
      then:
        - lambda: |-
            unsigned short canId = 500;

Home Assistant

Entities and Helpers

place the file packages/ha_stiebel_control.yaml in your /config/packages/ folder in Home Assistant.
add the package folder to your configuration.yaml under homeassistant (if not already set up)

homeassistant:
  packages: !include_dir_named packages

Dashboard

Install the lovelace card apexcharts-card
Install the lovelace card lovelace-mushroom
Create a new Dashboard, switch to RAW mode and paste the content of dashboard.yaml. The result should look similar to this:

Using

FIXME

Contributing

Pull requests are welcome. For major changes, please open an issue first to discuss what you would like to change.

Please make sure to update tests as appropriate.

License

[GPLv3] (https://www.gnu.org/licenses/gpl-3.0.en.html)

bullitt186/ha-stiebel-control