Tool to read and flash the MS45 DME. Can read/write full and partial binaries from the MS45.0 and MS45.1. It will automatically correct checksums and sign files that are flashed to the DME.
This application uses .Net Framework 4.5.2
Any INPA-compatible OBDII cable should work with this application. Make sure your cable latency is set to 1ms
You will need EdiabasLib.dll to compile and run this application. The application assumes you have an ediabas installation in the default directory along with E46, E60, E65, E83, or E85 daten files. If you don't have / want Ediabas installed, you will need to find a copy of MS450DS0.prg or 10MDS45.prg, and set the .config file to reflect the directory and filename of those files. Most of my testing has been with MS450DS0.prg, so I recommend using that.
Change the settings as necessary in the 'MS45 Flasher.exe.config' file. Default port is COM1, default sgbd directory is C:\Ediabas\ECU, and default sgbd is D_Motor.GRP (should automatically resolve to MS450DS0.prg if connected to an MS45 DME)
Start the application, connect your interface to your OBDII port, and click "Ident DME" If successful, the application should autopopulate some information from your DME
For the tune, simply click "Read DME".
If you would like to backup your full flash, check the "full binary" checkbox before clicking "Read DME" A full backup will result in two files. The _Flash file is the external flash of your DME, and the _mpc file contains the data that's internal to the CPU. You need both of these
Save the file(s) whereever you like
It is highly recommended you make a full backup before you flash your DME
To flash a tune:
- Click "Load File"
- Open the tune you'd like to flash
- Click "Flash Tune".
If successful, your DME should reboot and the application status should reflect "Flash Successful"
To flash a full binary:
- Check the "Full Binary" checkbox
- Click "Load File" and open the file that contains the external flash you'd like to use
- Click "Load File 2 (MPC)" and open the file that contains the mpc flash you'd like to use
- Click "Flash Program"
- NOTE: If the files do not match, you can render your DME unbootable. The application does do some basic checking, but it may not be fool proof
If the program version you flashed is different than what was on there before, you will also have to flash a tune. You can simply click "Flash Tune" to use the one embedded within the full file, or you can uncheck the checkbox and load an appropriate tune of your choice.
- EdiabasLib - Used to communicate with the DME
- Hassmaschine has been a tremendous help in disassembling the DME and understanding the how the code generally works. I likely never would have done much with the MS45 without his help
- See also the list of contributors who participated / will participate in this project.
If this application has been useful for you and you would like to go a bit further with tuning, please consider checking out bimmerlabs. The site is still growing, but our goal is to allow full control of most BMW DMEs.
This project is licensed under The GNU General Public License v3.0 - see the LICENSE file for details
This program is inherently invasive, and can render your DME unbootable and your car undriveable. Care must be taken when using this application. In no respect shall the authors or contributors incur any liability for any damages, including, but limited to, direct, indirect, special, or consequential damages arising out of, resulting from, or any way connected to the use of the application, whether or not based upon warranty, contract, tort, or otherwise; whether or not injury was sustained by persons or property or otherwise; and whether or not loss was sustained from, or arose out of, the results of, the item, or any services that may be provided by the authors and contributors.