/EasyNavGUI

Navigation GUI for MacroQuest

Primary LanguageLua

EasyNavGUI

Navigation GUI for MacroQuest Setup: Place the init.lua in the EasyNav folder Place the zone_connections.ini in the EasyNav folder Place the EasyNavGUI.lua in the lua folder

Command: /lua run easynav shortzonename

or

Command To Start EasyNavGui: /lua run EasyNavGui

You can create your own alias for yourself, group or all using eqbcs or dannet by typing the commands below.

Examples: /alias /ez /lua run easynav -To run easynav with the command /ez shortzonename

/alias /ezg /bcga //lua run easynav -To tell your group to run easynav using eqbc /ezg shortzonename

/alias /eza /bcaa //lua run easynav -To tell everyone connected to eqbc to run easynav /eza shortzonename

/alias /ezg /dgga /lua run easynav -To tell your group to run easynav using dannet /ezg shortzonename

/alias /eza /dga /lua run easynav -To tell everyone connected to dannet to run easynav /eza shortzonename

Running easynav without a specified zone will give you a list of available shortnames for the zone. Will use Magus, Priest of Discord, Translocators, Griffon Handlers, Herald, Provided you set up the alias as /ez Most instance zone you can just run /ez leave Some zones are set up to navigate floors, /ez floor1, /ez floor2 and so on. Disclaimer: This is work in progress and use at your own risk. I will not be held responsible for broken links or missing zone connections or if you type /ez poknowledge and end up in the guild lobby. I know braniac is working on easyfind, but until then...

UPDATE: Just a side note, there really is no need to edit the easynavgui unless you want to use eqbc for your group and all navigation. Then you would just change the' /dgge /lua run easynav' to '/bcga //lua run easynav' and the '/dga /lua run easynav' to '/bcaa //lua run easynav' The default will already run DanNet without any any aliases.