mbeddr.arduino
Background
This is a DSL to write programs for the Arduino platform. It is based on the mbeddr project which is an extensible C implementation in JetBrains MPS.
Currently this project nothing but a playground it offers some really limited support for the Arduino Uno and is likely to change and break stuff so this nothing you want to put you work on right now.
Installation
Prerequisites
Obviously you will need a working MPS and mbeddr installation. You will need at least version 0.6-EAP.
You can also use mbeddrs windows installer to get mbeddr if you are using windows.
Setup
You will need the following tools installed on you machine and available in your path. These should be available for any platform, though I have only tested it on Mac and Linux
Linux
On most Linux distributions you will get all these when you install the following packages:
avr-binutils avrdude avr-gcc avr-libc
You might also want to install
avr-gdb
But currently there is no support for direct debugging out of mbeddr.arduino!
Mac
You need to have a working Mac Ports installation to get the needed libraries. Then you can use the following commands to install the needed programs and libraries:
sudo port install avr-libc avr-gdb avrdude
Windows
On Windows you need to install WinAVR. Please make sure that you check the "Add to PATH" option in the installer.
Get it
You can grab the latest release from the release page. The release contains two parts:
mbeddr extensions
These are plugins for mebddr / MPS that extend mebddr with support for the Arduino platform.
Those mbeddr.arduino.core.zip file contains these. You need to put them in the plugins folder in
your MPS or mbeddr installation.
Arduino support library
This is a tiny C library that is used by the generator to handle some common use cases and to improve
the readability of the generated code. It is contained in the mbeddr.arduino.support.zip. You can put
it some where on you hard disk where you can find it later on. Please remember that path where you
put it, because you need to set it in the ArduinoConfiguration of your project.
Try it
Now open your favorite shell and navigate to solutions/arduino.samples/source_gen/arduino/samples/Blinker from the root of the source code.
You will find the generated source code from the sample here which you can build with a simple
make
This generates :
bin/main.o
arduino
arduino.hex
The arduino.hex is the interesting stuff since it the executable for the arduino. This can be flashed to a connected Arduino Uno via:
avrdude -F -V -c arduino -p ATMEGA328P -P /dev/ttyACM0 -b 115200 -U flash:w:arduino.hex
Now the Arduino will run a simple blinker sample the blinks the build in LED.
Build it
You can find the building instructions in the wiki
State
Currently this project only has bare minimum support for the Arduino Uno. It has some rough edges but it should be good to try it. To see what is missing have a look at the Issues.
For more information how stuff works have a look at the wiki which will contain a growing list of pages in the near future.