Cheap DIY solution to make a heater for hot-plate soldering.
- Plug the device to a common 12V DC power source that is able to provide 5 ampere.
- Place the object to be soldered on the heater plate.
- Switch on the heater with the red power button.
- Select a target temperature (the "Set" value on the display) with the potentiometer.
- When the solder is molten enough, turn off the heater with the red button. Note that there is no support to automatically follow a temperature profile.
To switch the device between centigrade and fahrenheit, press the power button more than 3 seconds when turning it on.
- Set: Selected target temperature
- Temp: Temperature as measured
The numbers in the bottom area are used to understand the internal working and show the following things:
- Duty cycle of the heater
- Supply voltage
- Current through the top heater trace
The heater plate contains two copper traces (one at the top and one at the bottom) that can individually be connected to the supply voltage. These traces have a resistance of about 3.5 ohm each (within manufacturing tolerances) and will produce the heat for the process. For fine control of the output power, the controller circuit will quickly turn each heater trace on and off.
To receive feeedback about the current temperature, the controller circuit contains a Hall-effect sensor to monitor the electric current running through the top heater trace. Combined with the voltage that is also monitored, the resistance of this trace can be computed. As the specific resistance of copper changes with temperature, the current temperature can be computed.
Note that due to tolerances in PCB manufacturing and in the electronic parts, the temperature measurement may be not very precise. You will need to experimentally find the best temperature setting for your specific application.
The repeated thermal stress on the heater will probably cause it to get damaged eventually. In this case it is quite easy to have a replacement PCB made using the Gerber files. As you will probably get multiple parts from your manufacturer, this should then last for a considerable time. You can also just turn over the heater plate if the top surface gets scratched or is otherwise worn out, so you can continue to use it.