A simple a lightweight gcode interpreter for arduino nano
Create by costycnc for costycnc foam cutter macchine www.costycnc.it
Support only X and Y axe!!!
Support only G92 for make X and Y zero!!!
Support only G90 and G91 !!!
Measure in mm
All another commands will be ignored!!!
For unipolar stepper motor 28byj-48.
Arduino nano pins >> Axe Y A0,A1,A2,A3 >>> Axe X D2,D3,D4,D5
G command need to be in separate lines. If two g command in same line will be read last g value!
That is all :)
A small program to test this firmware > https://www.costycnc.it/cm8