/pyatag-ha

Homeassistant component for Atag One thermostat

Primary LanguagePython

ATAG ONE Custom Component for Home Assistant

Instalation

  1. Add files to custom_components directory or use custom_updater component

    • .homeassistant/custom_components/atag/*.py

  2. Add the new platform in the configuration.yaml to enable climate, water_heater and default sensors to HA. Uses Auto-discovery if no host data is provided:

     atag:

  3. Add optional configuration parameters if necessary:

     atag:
   host: # in case autodiscovery fails
   port: 10000 # in case connecting through port redirect
   email: 
   interface:  # in case autodiscovery fails (e.g. 'eth0')
   scan_interval: 
   sensors:
     - device_id
     - device_status
     - connection_status
     - date_time
     - current_temperature
     - outside_temp
     - outside_temp_avg
     - weather_status
     - pcb_temp
     - temperature
     - operation_mode
     - ch_water_pressure
     - ch_water_temp
     - ch_return_temp
     - dhw_water_temp
     - dhw_water_pres
     - dhw_flow_rate
     - boiler_status
     - boiler_config
     - burning_hours
     - voltage
     - current
     - flame_level
     - report_time
     - ch_status
     - ch_control_mode
     - ch_mode_duration
     - extend_duration
     - fireplace_duration
     - vacation_duration
     - dhw_temp_setp
     - dhw_status
     - dhw_mode
     - dhw_mode_temp
     - weather_current_temperature

  4. Additional sensors can be added (but will show a warning), anything in the retrieve reply should be possible:

    "device_id", "device_status", "connection_status", "date_time",
"report_time", "burning_hours", "device_errors", "boiler_errors", "room_temp",
"outside_temp", "dbg_outside_temp", "pcb_temp", "ch_setpoint", "dhw_water_temp",
"ch_water_temp", "dhw_water_pres", "ch_water_pres", "ch_return_temp",
"boiler_status", "boiler_config", "ch_time_to_temp", "shown_set_temp",
"power_cons", "tout_avg", "rssi", "current", "voltage", "charge_status",
"lmuc_burner_starts", "dhw_flow_rate", "resets", "memory_allocation",
"boiler_temp", "boiler_return_temp", "min_mod_level", "rel_mod_level",
"boiler_capacity", "target_temp", "overshoot", "max_boiler_temp", "alpha_used",
"regulation_state", "ch_m_dot_c", "c_house", "r_rad", "r_env", "alpha", "alpha_max",
"delay", "mu", "threshold_offs", "wd_k_factor ", "wd_exponent",
"lmuc_burner_hours", "lmuc_dhw_hours", "KP", "KI",
"ch_status", "ch_control_mode", "ch_mode", "ch_mode_duration", "ch_mode_temp",
"dhw_temp_setp", "dhw_status", "dhw_mode", "dhw_mode_temp", "weather_temp",
"weather_status", "vacation_duration", "extend_duration", "fireplace_duration"