0.9.6.21 - After updating impossible to pass Arn/Disarm with my powermax Pro
Closed this issue · 2 comments
Hi @davesmeghead , i have a problem after new update...
At this time, impossible for me to pass the powermac Arm or Disarm with Home Assistant.
This is my log file:
Could you help me pease ? I read a similar problem, on your GitHub but not with the same panel...
Thanks
I reload, reboot, wait a long time, and now it"s ok...Strange
From your log file I can explain it
Lines 265 and 266
2024-08-19 14:12:20.464 DEBUG (SyncWorker_0) [custom_components.visonic.client] P0 Send command to Visonic Alarm Panel: ARM_AWAY
2024-08-19 14:12:20.466 DEBUG (SyncWorker_0) [custom_components.visonic.client] P0 Client: Sending HA Event visonic_alarm_command_to_panel {'panel': 0, 'panel_id': 'alarm_control_panel.visonic_alarm', 'action': 'armdisarm', 'ready': False, 'open': ['binary_sensor.visonic_z04'], 'bypass': [], 'tamper': [], 'zonetamper': [], 'command': 'Arm_Away', 'reason': 0, 'reason_str': 'Success', 'message': 'Request Arm/Disarm Success, sent Command to Panel'}
Please note this information
'ready': False, 'open': ['binary_sensor.visonic_z04']
The panel is "Not Ready" as Zone 4 is open.
The panel will only Arm Away if the Zone is closed or bypassed.
I assume that after you rebooted and waited a long time, Zone 4 was closed
You can alter your config to create Home Assistant Notifications or you can create an automation to respond to the HA Event that is generated i.e. line 266 details the Event Data.
Regards
Dave