/litemount

Mounting for Ubnt LiteBeam series, meant to be 3d printed

litemount

what is this?

This is a mounting unit for the LiteBeam series from Ubnt. Only tested with LiteBeam M5. Idea is to use a commercially available suction cup base and print a little arm with 2 additional degrees of freedom.

general stuff

  • all holes are for M5 screws
  • use washers, if you have the big ones with 15mm outer diameter (e.g. DIN 9021)

important print settings

  • lots of infill (80% is okay)
  • have a look at the layers before you print, you might have to activate support

slic3r printing

  • activate support
  • activate "don't support bridges"
  • pattern: pillars This should build a support only under the screw hole in the middle of the part.

where do I get the suction cup base?

In china: http://www.aliexpress.com/item/KingMa-Suction-Cup-Adapter-Window-7CM-Diameter-For-Gopro-Hero-Action-Camera-Suction-Cup-Rotation-Base/32565858696.html?ws_ab_test=searchweb201556_9,searchweb201644_5_505_506_503_504_502_10001_10002_10016_10017_10010_10005_10011_10006_10003_10004_10009_10008,searchweb201560_8,searchweb1451318400_-1,searchweb1451318411_6450&btsid=e44f0e6a-43f4-45e2-9633-2d16d398c042