Software for pollution measuring device running on raspberry pi
- Gnasnomer
- 0.1.0
pip install -e git+https://github.com/dekomote/gnasnomer.git\#egg\=gnasnomer
or
clone and do setup.py install.
Install deps listed in requirements.txt if not already installed then
Check usage: gnasnomer -h
Runs on GNU/Linux and you need the serial pollution sensor (SDS family) Optionally, if you stick a GPS device and run the gpsd daemon, it will also gather and post GPS coordinates as to where the reading was done.
To run the GPSd:
sudo gpsd -n -N -D 5 /dev/ttyXXXX
Usually, it's /dev/ttyACM0.
Omit -n if you want less polling.